Cisco Nexus 3000 series - Clear Mpls Strip Label Dynamic

Send comments to nexus3k-docfeedback@cisco.com
-SM-29
Cisco Nexus 3000 Series NX-OS System Management Command Reference
OL-29557-04
Chapter System Management Commands
clear mpls strip label dynamic
clear mpls strip label dynamic
To clear dynamic label entries from the MPLS label table, use the clear mpls strip label dynamic
command.
clear mpls strip label dynamic
Syntax Description This command has no arguments or keywords
Command Default None
Command Modes EXEC mode
Command History
Examples This example shows how to clear dynamic label entries:
switch(config)# sh mpls strip labels
MPLS Strip Labels:
Total : 2
Static : 0
Legend: * - Static Label
Interface - where label was first learned
Idle-Age - Seconds since last use
SW-Counter- Packets received in Software
HW-Counter- Packets switched in Hardware
--------------------------------------------------------------------------------
Label Interface Idle-Age SW-Counter HW-Counter
--------------------------------------------------------------------------------
450000 Eth1/47 1 2 0
45000 Eth1/47 1 1 0
switch(config)# clear mpls strip labels dynamic
switch(config)# sh mpls strip labels
MPLS Strip Labels:
Release Modification
6.0(2)U2(5) This command was introduced.