Cisco Nexus 3000 series - Show Ntp Source

Send comments to nexus3k-docfeedback@cisco.com
-SM-245
Cisco Nexus 3000 Series NX-OS System Management Command Reference
OL-29557-04
Chapter System Management Commands
show ntp source
show ntp source
To display information about the Network Time Protocol (NTP) source, use the show ntp source
command.
show ntp source
Syntax Description This command has no arguments or keywords.
Defaults None
Command Modes Any command mode
Command History
Usage Guidelines This command does not require a license.
Examples This example shows how to display the NTP source information:
switch(config)# show ntp source
Related Commands
Release Modification
6.0(2)U(2)1 This command was introduced.
Command Description
ntp source Configures the NTP source.