Cisco Nexus 3000 series - Vrf (ERSPAN)

Send comments to nexus3k-docfeedback@cisco.com
-SM-332
Cisco Nexus 3000 Series NX-OS System Management Command Reference
OL-29557-04
Chapter System Management Commands
vrf (ERSPAN)
vrf (ERSPAN)
To configure a virtual routing and forwarding (VRF) instance for Encapsulated Remote Switched Port
Analyzer (ERSPAN) traffic forwarding in the source, use the vrf command. To revert to the default
settings, use the no form of this command.
vrf {vrf_name | default | management}
no vrf {vrf_name | default | management}
Syntax Description
Command Default None
Command Modes ERSPAN session configuration mode
Command History
Usage Guidelines This command does not require a license.
Examples This example shows how to configure a VRF instance for the ESRSPAN source:
switch# configure terminal
switch(config)# monitor session 1 type erspan-source
switch(config-erspan-src)# vrf default
switch(config-erspan-src)#
Related Commands
vrf_name Name of the VRF. The VRF name can be any case-sensitive, alphanumeric
string up to 32 characters.
default Specifies the default VRF instance.
management Specifies the management VRF instance.
Release Modification
5.0(3)U2(2) This command was introduced.
Command Description
monitor-session Enters the monitor configuration mode for configuring an ERSPAN session
for analyzing traffic between ports.
show monitor session Displays information about the Ethernet Switched Port Analyzer (SPAN) or
ERSPAN monitor session.