Cisco Nexus 3000 series - Ip Host

Send comments to nexus3k-docfeedback@cisco.com
-SM-94
Cisco Nexus 3000 Series NX-OS System Management Command Reference
OL-29557-04
Chapter System Management Commands
ip host
ip host
To define static hostname-to-address mappings in the Domain Name System (DNS) hostname cache, use
the ip host command. To remove a hostname-to-address mapping, use the no form of this command.
ip host name address1 [address2... address6]
no ip host name address1 [address2... address6]
Syntax Description
Command Default None
Command Modes Global configuration mode
Command History
Usage Guidelines Use the ip host command to add a static host name to DNS.
Examples This example shows how to configure a static hostname:
switch# configure terminal
switch(config)# ip host mycompany.com 192.0.2.1
switch(config)#
Related Commands
name Hostname. The name can be any case-sensitive, alphanumeric string
up to 80 characters.
address1 IPv4 address in the x.x.x.x format.
address2 ... address6 (Optional) Up to five additional IPv4 addresses in the x.x.x.x format.
Release Modification
5.0(3)U1(1) This command was introduced.
Command Description
show hosts Displays information about the IP domain name configuration.