Cisco Nexus 3000 series - Feature Sflow

Send comments to nexus3k-docfeedback@cisco.com
-SM-80
Cisco Nexus 3000 Series NX-OS System Management Command Reference
OL-29557-04
Chapter System Management Commands
feature sflow
feature sflow
To enable the scheduler feature on a Cisco NX-OS device, use the feature sflow command. To disable
the schedule feature, use the no form of this command.
feature sflow
no feature sflow
Syntax Description This command has no arguments or keywords.
Defaults Disabled
Command Modes Global configuration mode
Command History
Usage Guidelines This command does not require a license.
Examples This example shows how to enable the sFlow feature on a Cisco NX-OS device:
switch# configure terminal
switch(config)# feature sflow
This example shows how to disable the sFlow feature on a Cisco NX-OS device:
switch(config)# no feature sflow
switch(config)#
Related Commands
Release Modification
5.0(3)U4(1) This command was introduced.
Command Description
sflow sampling-rate .