Cisco Nexus 3000 series - Ntp Source

Send comments to nexus3k-docfeedback@cisco.com
-SM-150
Cisco Nexus 3000 Series NX-OS System Management Command Reference
OL-29557-04
Chapter System Management Commands
ntp source
ntp source
To configure the Network Time Protocol (NTP) source, use the ntp source command. To remove the
NTP source, use the no form of this command.
ntp source addr
no ntp source addr
Syntax Description
Defaults None
Command Modes Global configuration mode
Command History
Usage Guidelines This command does not require a license.
Examples This example shows how to configure the NTP source:
switch(config)# ntp source 192.0.2.3
This example shows how to remove the NTP source:
switch(config)# no ntp source 192.0.2.3
Related Commands
addr IPv4 or IPv6 address of the source. The IPv4 address format is dotted decimal,
x.x.x.x. The IPv6 address format is hex A:B::C:D.
Release Modification
6.0(2)U(2)1 This command was introduced.
Command Description
show ntp source Displays information about the NTP source.