Cisco Nexus 3000 series - Ntp Disable

Send comments to nexus3k-docfeedback@cisco.com
-SM-138
Cisco Nexus 3000 Series NX-OS System Management Command Reference
OL-29557-04
Chapter System Management Commands
ntp disable
ntp disable
To disable Network Time Protocol (NTP), use the ntp disable command. To reenable NTP, use the no
form of this command.
ntp disable {ip | ipv6}
no ntp disable {ip | ipv6}
Syntax Description
Defaults Enabled
Command Modes Interface configuration mode
Command History
Usage Guidelines This command does not require a license.
Examples This example shows how to disable NTP:
switch# ntp disable
ip Disables IPv4 on the interface.
ipv6 Disables IPv6 on the interface.
Release Modification
6.0(2)U(2)1 This command was introduced.