Cisco Nexus 3000 series - Page 258

Send comments to nexus3k-docfeedback@cisco.com
-SM-234
Cisco Nexus 3000 Series NX-OS System Management Command Reference
OL-29557-04
Chapter System Management Commands
show mpls strip labels
This example shows how to display only static MPLS labels:
switch(config)# show mpls strip labels static
MPLS Strip Labels:
Total : 3005
Static : 5
Legend: * - Static Label
Interface - where label was first learned
Idle-Age - Seconds since last use
SW-Counter- Packets received in Software
HW-Counter- Packets switched in Hardware
--------------------------------------------------------------------------------
Label Interface Idle-Age SW-Counter HW-Counter
--------------------------------------------------------------------------------
* 300 None <User> 403 0 0
* 100 None <User> 416 0 0
* 25000 None <User> 869 0 0
* 20000 None <User> 869 0 0
* 21000 None <User> 869 0 0
Related Commands Command Description
mpls strip Enables the MPLS stripping feature.
mpls strip dest-mac Configures the destination MAC address for stripped egress frames.
mpls strip label Adds or deletes static MPLS labels.
mpls strip label-age Configures MPLS label aging.
clear mpls strip label
dynamic
Clears dynamic label entries.