Cisco Nexus 3000 series - Page 36

Send comments to nexus3k-docfeedback@cisco.com
-SM-12
Cisco Nexus 3000 Series NX-OS System Management Command Reference
OL-29557-04
Chapter System Management Commands
action reload
action reload
To specify the action of reloading the Cisco Nexus 3000 Series switch software when an Embedded
Event Manager (EEM) applet is triggered, use the action reload command. To remove the action of
reloading the Cisco Nexus 3000 Series switch software, use the no form of this command.
action label num1 [.num2] reload
no action label num1 [.num2] reload
Syntax Description
Defaults None
Command Modes Embedded event manager configuration mode
Command History
Usage Guidelines This command does not require a license.
Examples This example shows how to specify the action of reloading the Cisco Nexus 3000 Series switch software
when an EEM applet is triggered:
switch# configure terminal
switch(config)# event manager applet reload-applet
switch(config-applet)# action 1.5 reload
switch(config-applet)#
Related Commands
label num1 [.num2] Unique identifier that can be any string value. Actions are sorted and run in an
ascending alphanumeric sequence using the label as the sort key. The range for
num1 is from 1 to 16 and the range for num2 is from 0 to 9.
Release Modification
5.0(3)U3(1) This command was introduced.
Command Description
action cli Configures a virtual shell (VSH) command string to be executed when an
Embedded Event Manager (EEM) applet is triggered.
action counter set or modify a named counter when an Embedded Event Manager (EEM)
applet is triggered.
action event-default Specifies that the default action for the event is to be performed when an
Embedded Event Manager (EEM) applet is triggered.
action policy-default Enables the default action of the policy being overridden.