D-Link xStack DGS-3120 Series User Manual

xStack
®
DGS-3120 Series Layer 3 Managed Gigabit Ethernet Switch CLI Reference Guide
1012
DGS-3120-24TC:admin# config syslog source_ipif none
Command: config syslog source_ipif none
Success
DGS-3120-24TC:admin#
105-2 show syslog source_ipif
Description
This command is used to display the syslog source IP interface.
Format
show syslog source_ipif
Parameters
None.
Restrictions
None.
Example
Show syslog source IP interface:
DGS-3120-24TC:admin#show syslog source_ipif
Command: show syslog source_ipif
Syslog Source IP Interface Configuration:
IP Interface : ipif3
IPv4 Address : 14.0.0.5
IPv6 Address : None
DGS-3120-24TC:admin#
105-3 config trap source_ipif
Description
This command is used to configure trap source IP interface.
Format
config trap source_ipif [<ipif_name 12> {<ipaddr> | <ipv6addr> } | none]

D-Link xStack DGS-3120 Series Specifications

General

MAC Address Table	16K entries
Ports	10/100/1000BASE-T ports
VLANs	4094
Jumbo Frame	Up to 9KB
Power Supply	Internal power supply (depending on model)
Power over Ethernet (PoE)	No
Layer 3 Features	RIP
Quality of Service (QoS)	8 queues per port, DiffServ
Security Features	ACLs
Management	Web-based, CLI, SNMP
Operating Temperature	0°C to 40°C
Storage Temperature	-40°C to 70°C
SFP Ports	Combo 10/100/1000BASE-T/SFP ports and/or dedicated SFP/SFP+ ports (depending on model)