D-Link xStack DGS-3120 Series User Manual

xStack
®
DGS-3120 Series Layer 3 Managed Gigabit Ethernet Switch CLI Reference Guide
626
Chapter 62 MLD Proxy Command List
(RI Mode Only)
enable mld_proxy
disable mld_proxy
config mld_proxy downstream_if [add | delete] vlan [<vlan_name 32> | vlanid <vidlist>]
config mld_proxy upstream_if {vlan [<vlan_name 32> | vlanid <vlanid 1-4094>] | router_ports
[add | delete] <portlist> | source_ip <ipv6addr> | unsolicited_report_interval <sec 0-25>}(1)
show mld_proxy {group}
62-1 enable mld_proxy
Description
This command is used to enable the MLD proxy on the switch.
Format
enable mld_proxy
Parameters
None.
Restrictions
Only Administrator, Operator and Power-User level users can issue this command.
Example
To enable the MLD proxy:
DGS-3120-24TC:admin#enable mld_proxy
Command: enable mld_proxy
Success.
DGS-3120-24TC:admin#
62-2 disable mld_proxy
Description
This command is used to disable the MLD proxy on the switch.
Format
disable mld_proxy

D-Link xStack DGS-3120 Series Specifications

General

MAC Address Table	16K entries
Ports	10/100/1000BASE-T ports
VLANs	4094
Jumbo Frame	Up to 9KB
Power Supply	Internal power supply (depending on model)
Power over Ethernet (PoE)	No
Layer 3 Features	RIP
Quality of Service (QoS)	8 queues per port, DiffServ
Security Features	ACLs
Management	Web-based, CLI, SNMP
Operating Temperature	0°C to 40°C
Storage Temperature	-40°C to 70°C
SFP Ports	Combo 10/100/1000BASE-T/SFP ports and/or dedicated SFP/SFP+ ports (depending on model)