D-Link xStack DGS-3120 Series - Chapter 80 Protocol Independent Multicast (PIM) Command List (RI Mode Only)

xStack
®
DGS-3120 Series Layer 3 Managed Gigabit Ethernet Switch CLI Reference Guide
784
Chapter 80 Protocol Independent
Multicast (PIM) Command
List (RI Mode Only)
config pim [[ipif <ipif_name 12> | all] {hello <sec 1-18724> | jp_interval <sec 1-18724> | state
[enable | disable] | mode [dm | sm | sm-dm] | dr_priority <uint 0-4294967294>}(1) |
register_probe_time <value 1-127> | register_suppression_time <value 3-255>]
enable pim
disable pim
show pim neighbor {ipif <ipif_name 12> | ipaddress <network_address>}
show pim {ipif <ipif_name 12>}
config pim cbsr [ipif <ipif_name 12> {priority [-1 | <value 0-255>]} | hash_masklen <value 0-32> |
bootstrap_period <value 1-255>]
show pim cbsr {ipif <ipif_name 12>}
config pim crp {holdtime <value 0-255> | priority <value 0-255> | wildcard_prefix_cnt [0 | 1]}
create pim crp group <network_address> rp <ipif_name 12>
delete pim crp group <network_address>
show pim crp
config pim last_hop_spt_switchover [never | immediately]
show pim ipmroute
create pim static_rp group <network_address> rp <ipaddr>
delete pim static_rp group <network_address>
show pim static_rp
show pim rpset
create pim register_checksum_include_data rp_address <ipaddr>
delete pim register_checksum_include_data rp_address <ipaddr>
show pim register_checksum_include_data_rp_list
config pim-ssm {state [enable | disable] | group_range [default | <network_address>]}(1)
show pim-ssm
80-1 config pim
Description
This command is used to configure the PIM settings.
Format
config pim [[ipif <ipif_name 12> | all] {hello <sec 1-18724> | jp_interval <sec 1-18724> | state
[enable | disable] | mode [dm | sm | sm-dm] | dr_priority <uint 0-4294967294>}(1) |
register_probe_time <value 1-127> | register_suppression_time <value 3-255>]
Parameters
ipif - Specify the IP interface name.
<ipif_name 12> - Enter the IP interface name used here. This name can be up to 12
characters long.
all - Specify that all the IP interfaces will be used.
hello - Specify the time between issuing hello packets to find neighboring routers.