D-Link xStack DGS-3120 Series User Manual

xStack
®
DGS-3120 Series Layer 3 Managed Gigabit Ethernet Switch CLI Reference Guide
583
DGS-3120-24TC:admin# disable loopdetect
Command: disable loopdetect
Success.
DGS-3120-24TC:admin#
54-5 show loopdetect
Description
This command is used to display the LBD global configuration.
Format
show loopdetect
Parameters
None.
Restrictions
Only Administrator and Operator-level users can issue this command.
Example
To show the LBD global settings:
DGS-3120-24TC:admin#show loopdetect
Command: show loopdetect
LBD Global Settings
---------------------------
Status : Disabled
Mode : Port-based
Interval : 10 sec
Recover Time : 60 sec
Trap State : None
Log State : Enabled
Function Version : v4.04
DGS-3120-24TC:admin#
54-6 show loopdetect ports
Description
This command is used to display the LBD per-port configuration.

D-Link xStack DGS-3120 Series Specifications

General

MAC Address Table	16K entries
Ports	10/100/1000BASE-T ports
VLANs	4094
Jumbo Frame	Up to 9KB
Power Supply	Internal power supply (depending on model)
Power over Ethernet (PoE)	No
Layer 3 Features	RIP
Quality of Service (QoS)	8 queues per port, DiffServ
Security Features	ACLs
Management	Web-based, CLI, SNMP
Operating Temperature	0°C to 40°C
Storage Temperature	-40°C to 70°C
SFP Ports	Combo 10/100/1000BASE-T/SFP ports and/or dedicated SFP/SFP+ ports (depending on model)