D-Link xStack DGS-3120 Series User Manual

xStack
®
DGS-3120 Series Layer 3 Managed Gigabit Ethernet Switch CLI Reference Guide
159
Example
To disable TELNET:
DGS-3120-24TC:admin# disable telnet
Command: disable telnet
Success.
DGS-3120-24TC:admin#
12-8 enable web
Description
This command is used to manage the Switch via HTTP based management software. Use the
command to enable HTTP and configure port number.
Format
enable web {<tcp_port_number 1-65535>}
Parameters
<tcp_port_number 1-65535> - (Optional) The TCP port number. TCP ports are numbered
between 1 and 65535. The “well-known” TCP port for the WEB protocol is 80.
Restrictions
Only Administrator and Operator-level users can issue this command.
Example
To enable HTTP and configure port number:
DGS-3120-24TC:admin#enable web 80
Command: enable web 80
Note: SSL will be disabled if web is enabled.
Success.
DGS-3120-24TC:admin#
12-9 disable web
Description
This command is used to manage the Switch via HTTP based management software. Use the
command to disable HTTP.
Format
disable web

D-Link xStack DGS-3120 Series Specifications

General

MAC Address Table	16K entries
Ports	10/100/1000BASE-T ports
VLANs	4094
Jumbo Frame	Up to 9KB
Power Supply	Internal power supply (depending on model)
Power over Ethernet (PoE)	No
Layer 3 Features	RIP
Quality of Service (QoS)	8 queues per port, DiffServ
Security Features	ACLs
Management	Web-based, CLI, SNMP
Operating Temperature	0°C to 40°C
Storage Temperature	-40°C to 70°C
SFP Ports	Combo 10/100/1000BASE-T/SFP ports and/or dedicated SFP/SFP+ ports (depending on model)