D-Link xStack DGS-3120 Series User Manual

xStack
®
DGS-3120 Series Layer 3 Managed Gigabit Ethernet Switch CLI Reference Guide
514
Chapter 48 IPv6 Route Command List
create ipv6route [default | <ipv6networkaddr>] [[<ipif_name 12> <ipv6addr> | <ipv6addr>]
{<metric 1-65535>} {[primary|backup]} | ip_tunnel <tunnel_name 12>]
delete ipv6route [[default | <ipv6networkaddr>] [<ipif_name 12> <ipv6addr> | <ipv6addr> |
ip_tunnel <tunnel_name 12>] | all]
show ipv6route {[<ipv6networkaddr> | <ipv6addr>]} {[static | ripng | ospfv3 | hardware]}
48-1 create ipv6route
Description
This command is used to create an IPv6 static route. If the next hop is a global address, it is not
needed to indicate the interface name. If the next hop is a link local address, then the interface
name must be specified.
Format
create ipv6route [default | <ipv6networkaddr>] [[<ipif_name 12> <ipv6addr> | <ipv6addr>]
{<metric 1-65535>} {[primary|backup]} | ip_tunnel <tunnel_name 12>]
Parameters
default - Specify the default route.
<ipv6networkaddr> - Specify the destination network of the route. (RI and EI Mode Only)
<ipif_name 12> - Specify the interface for the route. This name can be up to 12 characters long.
<ipv6addr> - Specify the next hop address for this route.
<ipv6addr> - Specify the next hop address for this route.
<metric 1-65535> - (Optional) Enter the metric value here. The default setting is 1. This value
must between 1 and 65535.
primary - (Optional) Specify the route as the primary route to the destination.
backup - (Optional) Specify the route as the backup route to the destination. The backup route
can only be added when the primary route exists. If the route is not specified as the primary
route or the backup route, then it will be auto-assigned by the system. The first created is the
primary, the second created is the backup.
ip_tunnel - Specify the IP tunnel interface of the route. (RI Mode Only)
<tunnel_name 12> - Enter the IP tunnel interface name.
Restrictions
Only Administrator, Operator and Power-User level users can issue this command.
Example
To create an IPv6 route:

D-Link xStack DGS-3120 Series Specifications

General

MAC Address Table	16K entries
Ports	10/100/1000BASE-T ports
VLANs	4094
Jumbo Frame	Up to 9KB
Power Supply	Internal power supply (depending on model)
Power over Ethernet (PoE)	No
Layer 3 Features	RIP
Quality of Service (QoS)	8 queues per port, DiffServ
Security Features	ACLs
Management	Web-based, CLI, SNMP
Operating Temperature	0°C to 40°C
Storage Temperature	-40°C to 70°C
SFP Ports	Combo 10/100/1000BASE-T/SFP ports and/or dedicated SFP/SFP+ ports (depending on model)