D-Link xStack DGS-3120 Series User Manual

xStack
®
DGS-3120 Series Layer 3 Managed Gigabit Ethernet Switch CLI Reference Guide
614
Chapter 59 MD5 Configuration
Command List (RI Mode
Only)
create md5 key <key_id 1-255> <password 16>
config md5 key <key_id 1-255> <password 16>
delete md5 key <key_id 1-255>
show md5 {key <key_id 1-255>}
59-1 create md5
Description
This command is used to create an MD5 key table.
Format
create md5 key <key_id 1-255> <password 16>
Parameters
<key_id 1-255> - Enter the MD5 key to be added. This key must be between 1 and 255.
<password 16> - Enter an alphanumeric string of between 1 and 16, case-sensitive characters,
used to generate the Message Digest which is in turn used to authenticate OSPF packets
within the OSPF routing domain.
Restrictions
Only Administrator and Operator-level users can issue this command.
Example
To create an MD5 key table:
DGS-3120-24TC:admin#create md5 key 1 dlink
Command: create md5 key 1 dlink
Success.
DGS-3120-24TC:admin#
59-2 config md5
Description
This command is used to configure an MD5 key and password. The MD5 Configuration allows for
the entry of a 16 character Message Digest - version 5 (MD5) key which can be used to

D-Link xStack DGS-3120 Series Specifications

General

MAC Address Table	16K entries
Ports	10/100/1000BASE-T ports
VLANs	4094
Jumbo Frame	Up to 9KB
Power Supply	Internal power supply (depending on model)
Power over Ethernet (PoE)	No
Layer 3 Features	RIP
Quality of Service (QoS)	8 queues per port, DiffServ
Security Features	ACLs
Management	Web-based, CLI, SNMP
Operating Temperature	0°C to 40°C
Storage Temperature	-40°C to 70°C
SFP Ports	Combo 10/100/1000BASE-T/SFP ports and/or dedicated SFP/SFP+ ports (depending on model)