D-Link xStack DGS-3120 Series - Chapter 57 MAC-Based Access Control Command List

xStack
®
DGS-3120 Series Layer 3 Managed Gigabit Ethernet Switch CLI Reference Guide
594
Chapter 57 MAC-based Access Control
Command List
enable mac_based_access_control
disable mac_based_access_control
config mac_based_access_control password <passwd 16>
config mac_based_access_control password_type [manual_string | client_mac_address]
config mac_based_access_control method [local | radius]
config mac_based_access_control guest_vlan ports <portlist>
config mac_based_access_control ports [<portlist> | all] {state [enable | disable] | mode
[port_based | host_based] | aging_time [infinite | <min 1-1440>] | block_time <sec 0-300> |
max_users [<value 1-1000> | no_limit]}(1)
create mac_based_access_control [guest_vlan <vlan_name 32> | guest_vlanid <vlanid 1-
4094>]
delete mac_based_access_control [guest_vlan <vlan_name 32> | guest_vlanid <vlanid 1-
4094>]
clear mac_based_access_control auth_state [ports [all | <portlist>] | mac_addr <macaddr>]
create mac_based_access_control_local mac <macaddr> {[vlan <vlan_name 32> | vlanid <
vlanid 1-4094>]}
config mac_based_access_control_local mac <macaddr> [vlan <vlan_name 32> | vlanid
<vlanid 1-4094> | clear_vlan]
delete mac_based_access_control_local [mac <macaddr> | vlan <vlan_name 32> | vlanid
<vlanid 1-4094>]
config mac_based_access_control authorization attributes {radius [enable | disable] | local
[enable | disable]}(1)
show mac_based_access_control {ports {<portlist>}}
show mac_based_access_control_local {[mac <macaddr> | vlan <vlan_name 32> | vlanid
<vlanid 1-4094>]}
show mac_based_access_control auth_state ports {<portlist>}
config mac_based_access_control max_users [<value 1-1000> | no_limit]
config mac_based_access_control trap state [enable | disable]
config mac_based_access_control log state [enable | disable]
57-1 enable mac_based_access_control
Description
This command is used to enable MAC-based Access Control.
Format
enable mac_based_access_control
Parameters
None.
Restrictions
Only Administrator, Operator and Power-User level users can issue this command.