D-Link xStack DGS-3120 Series - Show Arpentry

xStack
®
DGS-3120 Series Layer 3 Managed Gigabit Ethernet Switch CLI Reference Guide
145
Restrictions
Only Administrator, Operator and Power-User level users can issue this command.
Example
To clear the ARP table:
DGS-3120-24TC:admin# clear arptable
Command: clear arptable
Success.
DGS-3120-24TC:admin#
8-6 show arpentry
Description
This command is used to displays the ARP table. You can filter the display by IP address, MAC
address, Interface name, or static entries.
Format
show arpentry {ipif <ipif_name 12> | ipaddress <ipaddr> | static | mac_address <macaddr>}
Parameters
ipif - (Optional) The name of the IP interface the end node or station for which the ARP table
entry was made, resides on.
<ipif_name 12> - Enter the IP interface name here. This value can be up to 12 characters
long.
ipaddress - (Optional) The IP address of the end node or station.
<ipaddr> - Enter the IP address here.
static - (Optional) Display the static entries in the ARP table.
mac_address - (Optional) Displays the ARP entry by MAC address.
<macaddr> - Enter the MAC address here.
Restrictions
Only Administrator, Operator and Power-User level users can issue this command.
Example
To display the ARP table: