D-Link xStack DGS-3120 Series User Manual

xStack
®
DGS-3120 Series Layer 3 Managed Gigabit Ethernet Switch CLI Reference Guide
65
Parameters
None.
Restrictions
Only Administrator-level users can issue this command.
Example
To enable the password encryption:
DGS-3120-24TC:admin#enable password encryption
Command: enable password encryption
Success.
DGS-3120-24TC:admin#
5-4 disable password encryption
Description
This command is used to disable password encryption. The user account configuration information
will be stored in the configuration file, and can be applied to the system later.
When password encryption is disabled, if the user specifies the password in plain text form, the
password will be in plan text form. However, if the user specifies the password in encrypted form,
or if the password has been converted to encrypted form by the last enable password encryption
command, the password will still be in the encrypted form. It can not be reverted to the plaintext.
Format
disable password encryption
Parameters
None.
Restrictions
Only Administrator-level users can issue this command.
Example
To disable the password encryption:
DGS-3120-24TC:admin#disable password encryption
Command: disable password encryption
Success.
DGS-3120-24TC:admin#

D-Link xStack DGS-3120 Series Specifications

General

MAC Address Table	16K entries
Ports	10/100/1000BASE-T ports
VLANs	4094
Jumbo Frame	Up to 9KB
Power Supply	Internal power supply (depending on model)
Power over Ethernet (PoE)	No
Layer 3 Features	RIP
Quality of Service (QoS)	8 queues per port, DiffServ
Security Features	ACLs
Management	Web-based, CLI, SNMP
Operating Temperature	0°C to 40°C
Storage Temperature	-40°C to 70°C
SFP Ports	Combo 10/100/1000BASE-T/SFP ports and/or dedicated SFP/SFP+ ports (depending on model)