D-Link xStack DGS-3120 Series User Manual

xStack
®
DGS-3120 Series Layer 3 Managed Gigabit Ethernet Switch CLI Reference Guide
691
DGS-3120-24TC:admin#show packet ports 1:7
Command: show packet ports 1:7
Port Number : 1:7
==================================================================
Frame Size/Type Frame Counts Frames/sec
--------------- ---------------------- -----------
64 0 0
65-127 0 0
128-255 0 0
256-511 0 0
512-1023 0 0
1024-1518 0 0
Unicast RX 0 0
Multicast RX 0 0
Broadcast RX 0 0
Frame Type Total Total/sec
--------------- ---------------------- -----------
RX Bytes 0 0
RX Frames 0 0
TX Bytes 0 0
TX Frames 0 0
CTRL+C ESC q Quit SPACE n Next Page p Previous Page r Refresh
68-2 show error ports
Description
This command is used to display the error statistics for a range of ports.
Format
show errors ports <portlist>
Parameters
<portlist> - Specify a range of ports to be displayed.
Restrictions
None.
Example
To display the errors of the port 3 of unit 1:

D-Link xStack DGS-3120 Series Specifications

General

MAC Address Table	16K entries
Ports	10/100/1000BASE-T ports
VLANs	4094
Jumbo Frame	Up to 9KB
Power Supply	Internal power supply (depending on model)
Power over Ethernet (PoE)	No
Layer 3 Features	RIP
Quality of Service (QoS)	8 queues per port, DiffServ
Security Features	ACLs
Management	Web-based, CLI, SNMP
Operating Temperature	0°C to 40°C
Storage Temperature	-40°C to 70°C
SFP Ports	Combo 10/100/1000BASE-T/SFP ports and/or dedicated SFP/SFP+ ports (depending on model)