D-Link xStack DGS-3120 Series User Manual

xStack
®
DGS-3120 Series Layer 3 Managed Gigabit Ethernet Switch CLI Reference Guide
830
Restrictions
Only Administrator, Operator and Power-User level users can issue this command.
Example
To configure port list 1-4 as NNI port and set the TPID to 0x88A8:
DGS-3120-24TC:admin# config qinq ports 1:1-1:4 role nni outer_tpid 0x88A8
Command: config qinq ports 1:1-1:4 role nni outer_tpid 0x88A8
Success.
DGS-3120-24TC:admin#
83-5 show qinq
Description
This command is used to display the global QinQ status.
Format
show qinq
Parameters
None.
Restrictions
None.
Example
To display the global QinQ status:
DGS-3120-24TC:admin# show qinq
Command: show qinq
QinQ Status : Enabled
DGS-3120-24TC:admin#
83-6 show qinq inner_tpid
Description
This command is used to display the inner-TPID of a system.

D-Link xStack DGS-3120 Series Specifications

General

MAC Address Table	16K entries
Ports	10/100/1000BASE-T ports
VLANs	4094
Jumbo Frame	Up to 9KB
Power Supply	Internal power supply (depending on model)
Power over Ethernet (PoE)	No
Layer 3 Features	RIP
Quality of Service (QoS)	8 queues per port, DiffServ
Security Features	ACLs
Management	Web-based, CLI, SNMP
Operating Temperature	0°C to 40°C
Storage Temperature	-40°C to 70°C
SFP Ports	Combo 10/100/1000BASE-T/SFP ports and/or dedicated SFP/SFP+ ports (depending on model)