D-Link xStack DGS-3120 Series User Manual

xStack
®
DGS-3120 Series Layer 3 Managed Gigabit Ethernet Switch CLI Reference Guide
693
DGS-3120-24TC:admin# show utilization ports
Command: show utilization ports
Port TX/sec RX/sec Util Port TX/sec RX/sec Util
----- ---------- ---------- ---- ----- ---------- ---------- ----
1:1 0 0 0 1:21 0 0 0
1:2 0 0 0 1:22 0 0 0
1:3 0 0 0 1:23 0 0 0
1:4 0 0 0 1:24 0 0 0
1:5 0 0 0
1:6 0 0 0
1:7 0 0 0
1:8 0 0 0
1:9 0 0 0
1:10 0 0 0
1:11 0 0 0
1:12 0 0 0
1:13 0 0 0
1:14 0 0 0
1:15 0 0 0
1:16 0 0 0
1:17 0 0 0
1:18 0 0 0
1:19 0 0 0
1:20 0 0 0
CTRL+C ESC q Quit SPACE n Next Page p Previous Page r Refresh
To display the CPU utilization:
DGS-3120-24TC:admin#show utilization cpu
Command: show utilization cpu
CPU Utilization
-------------------------------------------------------------------------------
Five seconds - 10 % One minute - 10 % Five minutes - 10 %
CTRL+C ESC q Quit SPACE n Next Page p Previous Page r Refresh
68-4 show utilization dram
Description
This command is used to show DRAM memory utilization.
Format
show utilization dram {unit <unit_id>}

D-Link xStack DGS-3120 Series Specifications

General

MAC Address Table	16K entries
Ports	10/100/1000BASE-T ports
VLANs	4094
Jumbo Frame	Up to 9KB
Power Supply	Internal power supply (depending on model)
Power over Ethernet (PoE)	No
Layer 3 Features	RIP
Quality of Service (QoS)	8 queues per port, DiffServ
Security Features	ACLs
Management	Web-based, CLI, SNMP
Operating Temperature	0°C to 40°C
Storage Temperature	-40°C to 70°C
SFP Ports	Combo 10/100/1000BASE-T/SFP ports and/or dedicated SFP/SFP+ ports (depending on model)