D-Link xStack DGS-3120 Series - Chapter 87 Routing Information Protocol (RIP) Command List (RI Mode Only); Enable Rip

xStack
®
DGS-3120 Series Layer 3 Managed Gigabit Ethernet Switch CLI Reference Guide
861
Chapter 87 Routing Information
Protocol (RIP) Command
List (RI Mode Only)
enable rip
disable rip
config rip [ipif <ipif_name 12> | all] {authentication [enable <password 16> | disable] | tx_mode
[disable | v1_only | v1_compatible | v2_only] | rx_mode [v1_only| v2_only | v1_or_v2 | disable]
| state [enable | disable] | distribute_list_in [access_list <list_name 16> | none]}(1)
config rip timers {update <sec 5-65535> | timeout <sec 5-65535> | garbage_collection <sec 5-
65535>}(1)
show rip {ipif <ipif_name 12>}
87-1 enable rip
Description
This command is used to enable RIP for the Switch. The default setting is disabled.
Format
enable rip
Parameters
None.
Restrictions
Only Administrator, Operator and Power-User level users can issue this command.
Example
To enable RIP:
DGS-3120-24TC:admin#enable rip
Command: enable rip
Success.
DGS-3120-24TC:admin#
87-2 disable rip
Description
This command is used to disable RIP for the Switch.