D-Link xStack DGS-3120 Series - Disable Wac; Config Wac Ports

xStack
®
DGS-3120 Series Layer 3 Managed Gigabit Ethernet Switch CLI Reference Guide
1093
DGS-3120-24TC:admin# enable wac
Command: enable wac
Success.
DGS-3120-24TC:admin#
120-2 disable wac
Description
This command is used to disable WAC function; all authentication entries related to WAC will be
deleted.
Format
disable wac
Parameters
None.
Restrictions
Only Administrator, Operator and Power-User level users can issue this command.
Example
To disable WAC:
DGS-3120-24TC:admin# disable wac
Command: disable wac
Success.
DGS-3120-24TC:admin#
120-3 config wac ports
Description
This command is used to configure state and other parameters of the ports.
Format
config wac ports [<portlist> | all] {state [enable | disable] | aging_time [infinite | <min 1-
1440>] | idle_time [infinite | <min 1-1440>] | block_time [<sec 0-300>]} (1)
Parameters
<portlist> - A port range to set their WAC state.