D-Link xStack DGS-3120 Series User Manual

xStack
®
DGS-3120 Series Layer 3 Managed Gigabit Ethernet Switch CLI Reference Guide
1038
DGS-3120-24TC:admin# enable sntp
Command: enable sntp
Success.
DGS-3120-24TC:admin#
110-5 disable sntp
Description
This command is used to turn off SNTP support.
Format
disable sntp
Parameters
None.
Restrictions
Only Administrator and Operator-level users can issue this command.
Example
To disable SNTP:
DGS-3120-24TC:admin# disable sntp
Command: disable sntp
Success.
DGS-3120-24TC:admin#
110-6 config time
Description
This command is used to configure time and date settings of the device.
Format
config time <date ddmthyyyy> <time hh:mm:ss>
Parameters
<date ddmthyyyy> - Specify the system clock date. An example would look like this:
'30jun2010'.
<time hh:mm:ss> - Specify the system clock time. An example would look like this: '12:00:00'.

D-Link xStack DGS-3120 Series Specifications

General

MAC Address Table	16K entries
Ports	10/100/1000BASE-T ports
VLANs	4094
Jumbo Frame	Up to 9KB
Power Supply	Internal power supply (depending on model)
Power over Ethernet (PoE)	No
Layer 3 Features	RIP
Quality of Service (QoS)	8 queues per port, DiffServ
Security Features	ACLs
Management	Web-based, CLI, SNMP
Operating Temperature	0°C to 40°C
Storage Temperature	-40°C to 70°C
SFP Ports	Combo 10/100/1000BASE-T/SFP ports and/or dedicated SFP/SFP+ ports (depending on model)