D-Link xStack DGS-3120 Series - Chapter 72 Password Recovery Command List

xStack
®
DGS-3120 Series Layer 3 Managed Gigabit Ethernet Switch CLI Reference Guide
744
Chapter 72 Password Recovery
Command List
enable password_recovery
disable password_recovery
show password_recovery
72-1 enable password_recovery
Description
This command is used to enable the password recovery mode.
NOTE: This command does not take effect until being saved.
Format
enable password_recovery
Parameters
None.
Restrictions
Only Administrator-level users can issue this command.
Example
To enable the password recovery mode:
DGS-3120-24TC:admin# enable password_recovery
Command: enable password_recovery
Success.
DGS-3120-24TC:admin#
72-2 disable password_recovery
Description
This command is used to disable the password recovery mode.
NOTE: This command does not take effect until being saved.