D-Link xStack DGS-3120 Series User Manual

xStack
®
DGS-3120 Series Layer 3 Managed Gigabit Ethernet Switch CLI Reference Guide
745
Format
disable password_recovery
Parameters
None.
Restrictions
Only Administrator-level users can issue this command.
Example
To disable the password recovery mode:
DGS-3120-24TC:admin# disable password_recovery
Command: disable password_recovery
Success.
DGS-3120-24TC:admin#
72-3 show password_recovery
Description
The command is used to display the password recovery state. The displayed content includes both
the running configuration and the NV-RAM configuration.
When the password recovery state is enabled, the user can reboot the Switch and enter the
Password Recovery mode. Otherwise, the user will not be able to enter the special recovery mode.
NOTE: Only the NV-RAM configuration will take effect when the Switch restarts, the running
configuration does not take effect until being saved. That means the password recovery is
determined by the state stored in the NV-RAM and takes effect when the Switch starts up
the next time. The Running Configuration is the current configured state of the password
recovery, the configuration is deleted without being saved, or becomes the NV-RAM
configuration when being saved.
Format
show password_recovery
Parameters
None.
Restrictions
Only Administrator-level users can issue this command.

D-Link xStack DGS-3120 Series Specifications

General

MAC Address Table	16K entries
Ports	10/100/1000BASE-T ports
VLANs	4094
Jumbo Frame	Up to 9KB
Power Supply	Internal power supply (depending on model)
Power over Ethernet (PoE)	No
Layer 3 Features	RIP
Quality of Service (QoS)	8 queues per port, DiffServ
Security Features	ACLs
Management	Web-based, CLI, SNMP
Operating Temperature	0°C to 40°C
Storage Temperature	-40°C to 70°C
SFP Ports	Combo 10/100/1000BASE-T/SFP ports and/or dedicated SFP/SFP+ ports (depending on model)