D-Link xStack DGS-3120 Series - Clear Counters

xStack
®
DGS-3120 Series Layer 3 Managed Gigabit Ethernet Switch CLI Reference Guide
695
DGS-3120-24TC:admin#show utilization flash
Command: show utilization flash
Unit 1 Flash Memory Utilization :
Total Flash : 29618 KB
Used Flash : 5422 KB
Utilization : 18 %
CTRL+C ESC q Quit SPACE n Next Page p Previous Page r Refresh
68-6 clear counters
Description
This command is used to clear the Switch’s statistics counters.
Format
clear counters {ports <portlist>}
Parameters
ports - (Optional) Specify a range of ports to be configured. The port list is specified by listing the
lowest switch number and the beginning port number on that switch, separated by a colon.
Then highest switch number, and the highest port number of the range (also separeted by a
colon) are specified. The beginning and end of the port list range are seperated by a dash.
<portlist> - Enter a list of ports used for the configuration here.
If no parameter is specified, the system will clear counters of all the ports .
Restrictions
Only Administrator and Operator-level users can issue this command.
Example
To clear the Switch’s statistics counters:
DGS-3120-24TC:admin# clear counters ports 2:7-2:9
Command: clear counters ports 2:7-2:9
Success.
DGS-3120-24TC:admin#