D-Link xStack DGS-3120 Series User Manual

xStack
®
DGS-3120 Series Layer 3 Managed Gigabit Ethernet Switch CLI Reference Guide
367
Restrictions
Only Administrator, Operator and Power-User level users can issue this command.
Example
To configure DVMRP configurations of IP interface called ‘System’:
DGS-3120-24TC:admin#config dvmrp ipif System neighbor_timeout 30 metric 1 probe
5
Command: config dvmrp ipif System neighbor_timeout 30 metric 1 probe 5
Success.
DGS-3120-24TC:admin#
30-2 enable dvmrp
Description
This command is used to enable the DVMRP global state on the Switch.
Format
enable dvmrp
Parameters
None.
Restrictions
Only Administrator, Operator and Power-User level users can issue this command.
Example
To enable DVMRP:
DGS-3120-24TC:admin#enable dvmrp
Command: enable dvmrp
Success.
DGS-3120-24TC:admin#
30-3 disable dvmrp
Description
This command is used to disable the DVMRP global state on the Switch.

D-Link xStack DGS-3120 Series Specifications

General

MAC Address Table	16K entries
Ports	10/100/1000BASE-T ports
VLANs	4094
Jumbo Frame	Up to 9KB
Power Supply	Internal power supply (depending on model)
Power over Ethernet (PoE)	No
Layer 3 Features	RIP
Quality of Service (QoS)	8 queues per port, DiffServ
Security Features	ACLs
Management	Web-based, CLI, SNMP
Operating Temperature	0°C to 40°C
Storage Temperature	-40°C to 70°C
SFP Ports	Combo 10/100/1000BASE-T/SFP ports and/or dedicated SFP/SFP+ ports (depending on model)