D-Link xStack DGS-3120 Series - Chapter 105 Syslog and Trap Source-Interface Command List

xStack
®
DGS-3120 Series Layer 3 Managed Gigabit Ethernet Switch CLI Reference Guide
1011
Chapter 105 Syslog and Trap Source-
interface Command List
config syslog source_ipif [<ipif_name 12> {<ipaddr> | <ipv6addr>} | none]
show syslog source_ipif
config trap source_ipif [<ipif_name 12> {<ipaddr> | <ipv6addr> } | none]
show trap source_ipif
105-1 config syslog source_ipif
Description
This command is used to configure syslog source IP interface.
Format
config syslog source_ipif [<ipif_name 12> {<ipaddr> | <ipv6addr>} | none]
Parameters
ipif - Specify the IP interface name. If only specify this parameter, the least IPv4 address and the
smallest IPv6 address of ipif_name will be used as source IP addresses.
<ipif_name 12> - Enter the IP interface name here. This name can be up to 12 characters
long.
<ipaddr> - (Optional) Enter the IP address used for the configuration here.
<ipv6addr> - (Optional) Enter the IPv6 address used for the configuration here.
none - Specify to clear the configured source IP interface.
Restrictions
Only Administrator and Operator-level users can issue this command.
Example
Configure syslog source IP interface:
DGS-3120-24TC:admin# config syslog source_ipif ipif3 14.0.0.5
Command: config syslog source_ipif add ipif3 14.0.0.5
Success
DGS-3120-24TC:admin#
To clear the configured source IP interface for syslog: