D-Link xStack DGS-3120 Series User Manual

xStack
®
DGS-3120 Series Layer 3 Managed Gigabit Ethernet Switch CLI Reference Guide
81
Example
To display all authentication server hosts:
DGS-3120-24TC:admin#show authen server_host
Command: show authen server_host
IP Address Protocol Port Timeout Retransmit Key
-------------------- -------- ----- ------- ---------- -----------------------
10.1.1.222 TACACS+ 15555 10 - This is a secret.
Total Entries : 1
DGS-3120-24TC:admin#
5-26 config authen parameter response_timeout
Description
This command is used to configure the amount of time waiting or user input on console, telnet,
SSH application.
Format
config authen parameter response_timeout <int 0-255>
Parameters
<int 0-255> - The amount of time for user input on console or telnet or SSH. 0 means there is no
time out. This value must be between 0 and 255. Default value is 30 seconds.
Restrictions
Only Administrator-level users can issue this command.
Example
To configure the amount of time waiting or user input to be 60 seconds:
DGS-3120-24TC:admin# config authen parameter response_timeout 60
Command: config authen parameter response_timeout 60
Success.
DGS-3120-24TC:admin#
5-27 config authen parameter attempt
Description
This command is used to configure the maximum attempts for user's trying to login or promote the
privilege on console, telnet, SSH application.

D-Link xStack DGS-3120 Series Specifications

General

MAC Address Table	16K entries
Ports	10/100/1000BASE-T ports
VLANs	4094
Jumbo Frame	Up to 9KB
Power Supply	Internal power supply (depending on model)
Power over Ethernet (PoE)	No
Layer 3 Features	RIP
Quality of Service (QoS)	8 queues per port, DiffServ
Security Features	ACLs
Management	Web-based, CLI, SNMP
Operating Temperature	0°C to 40°C
Storage Temperature	-40°C to 70°C
SFP Ports	Combo 10/100/1000BASE-T/SFP ports and/or dedicated SFP/SFP+ ports (depending on model)