D-Link xStack DGS-3120 Series - Chapter 103 Stacking Command List (EI and si Mode Only)

xStack
®
DGS-3120 Series Layer 3 Managed Gigabit Ethernet Switch CLI Reference Guide
1000
Chapter 103 Stacking Command List (EI
and SI Mode Only)
config box_priority current_box_id <value 1-6> priority <value 1-63>
config box_id current_box_id <value 1-6> new_box_id [auto | <value 1-6>]
show stack_information
show stack_device
config stacking_mode [disable | enable]
show stacking_mode
config stacking force_master_role state [enable | disable]
config stacking trap state [enable | disable]
config stacking log state [enable | disable]
NOTE: When the stacking function is enabled, non-PoE switches in the DGS-3120 series will have
PoE commands available.
103-1 config box_priority
Description
This command is used to configure the priority of switch, which will determines which box becomes
master. A lower number means a higher priority. The new priority will take effect after the Switch
was rebooted or when the topology changed.
Format
config box_priority current_box_id <value 1-6> priority <value 1-63>
Parameters
current_box_id - Specify the Switch being configured. The range is 1-m, where the m.is
determined by device type. For example, to the DGS3120 Series, it is 6.
<value 1-6> - Enter the current box ID here. This value must be between 1 and 6.
priority - Specify the priority assigned to the box, with lower number meaning higher priority. The
range is 1-63.
<value 1-63> - Enter the higher priority value here. This value must be between 1 and 63.
Restrictions
Only Administrator, Operator and Power-User level users can issue this command.
Example
To configure box priority: