D-Link xStack DGS-3120 Series - Config Lldp Ports

xStack
®
DGS-3120 Series Layer 3 Managed Gigabit Ethernet Switch CLI Reference Guide
557
Parameters
notification_interval - Specify the timer of notification interval for sending notification to
configured SNMP trap receiver(s). The default setting is 5 seconds.
<sec 5-3600> - Enter the notification interval value here. This value must be between 5 and
3600 seconds.
Restrictions
Only Administrator, Operator and Power-User level users can issue this command.
Example
To changes the notification interval to 10 second:
DGS-3120-24TC:admin#config lldp notification_interval 10
Command: config lldp notification_interval 10
Success.
DGS-3120-24TC:admin#
53-5 config lldp ports
Description
This command is used to configure each port for sending a notification to configure the SNMP trap
receiver(s).
Format
config lldp ports [<portlist> | all] [notification [enable | disable] | admin_status [tx_only |
rx_only | tx_and_rx | disable] | mgt_addr [ipv4 {<ipaddr>} | ipv6 {<ipv6addr>}] [enable |
disable] | basic_tlvs [[{all} | {port_description | system_name | system_description |
system_capabilities}] [enable | disable] | port_Id_subtype [mac_address | local]] |
dot1_tlv_pvid [enable | disable] | dot1_tlv_protocol_vid [vlan [all | <vlan_name 32>] | vlanid
<vidlist>] [enable | disable] | dot1_tlv_vlan_name [vlan [all | <vlan_name 32>] | vlanid
<vidlist>] [enable | disable] | dot1_tlv_protocol_identity [all | {eapol | lacp | gvrp | stp}]
[enable | disable] | dot3_tlvs [{all} | {mac_phy_configuration_status | link_aggregation |
power_via_mdi | maximum_frame_size}] [enable | disable]]
Parameters
<portlist> - Enter a list of ports used for the configuration here.
all - Specify that all the ports will be used for this configuration.
notification - Enables or disables the SNMP trap notification of LLDP data changes detected on
advertisements received from neighbor devices. The default notification state is disabled.
enable - Specify that the SNMP trap notification of LLDP data changes detected will be
enabled.
disable - Specify that the SNMP trap notification of LLDP data changes detected will be
disabled.
admin_status - Specify the per-port transmit and receive modes.
tx_only - Configure the specified port(s) to transmit LLDP packets, but block inbound LLDP