D-Link xStack DGS-3120 Series User Manual

xStack
®
DGS-3120 Series Layer 3 Managed Gigabit Ethernet Switch CLI Reference Guide
188
DGS-3120-24TC:admin#show authentication ports
Command: show authentication ports
Port Methods Auth Mode Authentication VLAN(s)
---- -------------- ----------- ----------------------
1:1 None Host-based
1:2 None Host-based
1:3 None Host-based
1:4 None Host-based
1:5 None Host-based
1:6 None Host-based
1:7 None Host-based
1:8 None Host-based
1:9 None Host-based
1:10 None Host-based
1:11 None Host-based
1:12 None Host-based
1:13 None Host-based
1:14 None Host-based
1:15 None Host-based
1:16 None Host-based
1:17 None Host-based
1:18 None Host-based
1:19 None Host-based
1:20 None Host-based
CTRL+C ESC q Quit SPACE n Next Page ENTER Next Entry a All
16-8 enable authorization attributes
Description
This command is used to enable authorization.
Format
enable authorization attributes
Parameters
None.
Restrictions
Only Administrator, Operator and Power-User level users can issue this command.
Example
This example sets authorization global state enabled:

D-Link xStack DGS-3120 Series Specifications

General

MAC Address Table	16K entries
Ports	10/100/1000BASE-T ports
VLANs	4094
Jumbo Frame	Up to 9KB
Power Supply	Internal power supply (depending on model)
Power over Ethernet (PoE)	No
Layer 3 Features	RIP
Quality of Service (QoS)	8 queues per port, DiffServ
Security Features	ACLs
Management	Web-based, CLI, SNMP
Operating Temperature	0°C to 40°C
Storage Temperature	-40°C to 70°C
SFP Ports	Combo 10/100/1000BASE-T/SFP ports and/or dedicated SFP/SFP+ ports (depending on model)