D-Link xStack DGS-3120 Series User Manual

xStack
®
DGS-3120 Series Layer 3 Managed Gigabit Ethernet Switch CLI Reference Guide
1115
Appendix A Password Recovery
Procedure
This chapter describes the procedure for resetting passwords on D-Link switches. Authenticating
any user who tries to access networks is necessary and important. The basic authentication
method used to accept qualified users is through a local login, utilizing a Username and Password.
Sometimes, passwords get forgotten or destroyed, so network administrators need to reset these
passwords. This chapter explains how the Password Recovery feature can help network
administrators reach this goal.
The following steps explain how to use the Password Recovery feature on D-Link devices to easily
recover passwords.
Complete these steps to reset the password:
1. For security reasons, the Password Recovery feature requires the user to physically
access the device. Therefore this feature is only applicable when there is a direct
connection to the console port of the device. It is necessary for the user needs to attach a
terminal or PC with terminal emulation to the console port of the Switch.
2. Power on the Switch. After the runtime image and UART init are loaded to 100%, the
Switch will allow 2 seconds for the user to press the hotkey [^] (Shift + 6) to enter the
“Password Recovery Mode.” Once the Switch enters the “Password Recovery Mode,” all
ports on the Switch will be disabled and all port LEDs will be lit.
Boot Procedure V3.00.501
-------------------------------------------------------------------------------
Power On Self Test ........................................ 100 %
MAC Address : 10-BF-48-D0-E0-E0
H/W Version : B1
Please Wait, Loading V4.00.015 Runtime Image .............. 100 %
UART init ................................................. 100 %
Starting runtime image
Password Recovery Mode
>
3. In the “Password Recovery Mode” only the following commands can be used.
Command Parameters
reset config
{force_agree}
The reset config command resets the whole configuration back to the
default values. If force_agree is specified, the configuration will reset to
default without the user’s agreement.
reboot
{force_agree}
The reboot command exits the Reset Password Recovery Mode and
restarts the Switch. A confirmation message will be displayed to allow the
user to save the current settings.
reset account The reset account command deletes all the previously created accounts.

D-Link xStack DGS-3120 Series Specifications

General

Brand	D-Link
Model	xStack DGS-3120 Series
Category	Switch
Language	English