D-Link xStack DGS-3120 Series User Manual

xStack
®
DGS-3120 Series Layer 3 Managed Gigabit Ethernet Switch CLI Reference Guide
1029
Chapter 108 Telnet Client Command List
telnet [<ipaddr> | <domain_name 255> | <ipv6addr>] {tcp_port <value 1-65535>}
108-1 telnet
Description
This command is used to start the telnet client to connect to the specific telnet server. The
parameters specified by the command will only be used for the establishment of this specific
session. They will not affect the establishment of other sessions.
Format
telnet [<ipaddr> | <domain_name 255> | <ipv6addr>] {tcp_port <value 1-65535>}
Parameters
<ipaddr> - The IP address of the Telnet server.
<domain_name 255> - Enter the domain name of the Telnet server.
<ipv6addr> - The IPv6 address of the Telnet server.
tcp_port - (Optional) Specify the telnet server port number to be connected. If not specified, the
default port is 23.
<value 1-65535> - Enter the TCP port number used here. This value must be between 1 and
65535.
Restrictions
None.
Example
Telnet to a Switch by specifying the IP address:
DGS-3120-24TC:admin# telnet 10.90.90.90
Command: telnet 10.90.90.90
DGS-XXXX Fast Ethernet Switch Command Line Interface
Firmware: Build 1.00.B01
Copyright(C) 2006-2009 D-Link Corporation. All rights reserved.
UserName:

D-Link xStack DGS-3120 Series Specifications

General

MAC Address Table	16K entries
Ports	10/100/1000BASE-T ports
VLANs	4094
Jumbo Frame	Up to 9KB
Power Supply	Internal power supply (depending on model)
Power over Ethernet (PoE)	No
Layer 3 Features	RIP
Quality of Service (QoS)	8 queues per port, DiffServ
Security Features	ACLs
Management	Web-based, CLI, SNMP
Operating Temperature	0°C to 40°C
Storage Temperature	-40°C to 70°C
SFP Ports	Combo 10/100/1000BASE-T/SFP ports and/or dedicated SFP/SFP+ ports (depending on model)