D-Link xStack DGS-3120 Series User Manual

xStack
®
DGS-3120 Series Layer 3 Managed Gigabit Ethernet Switch CLI Reference Guide
987
Format
config rmon trap {rising_alarm [enable | disable] | falling_alarm [enable | disable]} (1)
Parameters
rising_alarm - (Optional) Specify the trap state for rising alarm. The default state is enabled.
enable - Specify that the rising alarm function will be enabled.
disable - Specify that the rising alarm function will be disabled.
falling_alarm - (Optional) Specify the trap state for falling alarm. The default state is enabled.
enable - Specify that the falling alarm function will be enabled.
disable - Specify that the falling alarm function will be disabled.
Restrictions
Only Administrator-level users can issue this command.
Example
To configure the trap state for RMON events:
DGS-3120-24TC:admin# config rmon trap rising_alarm disable
Command: config rmon trap rising_alarm disable
Success.
DGS-3120-24TC:admin#
101-37 show rmon
Description
This command is used to display the RMON related setting.
Format
show rmon
Parameters
None.
Restrictions
Only Administrator-level users can issue this command.
Example
To display the RMON related setting:

D-Link xStack DGS-3120 Series Specifications

General

MAC Address Table	16K entries
Ports	10/100/1000BASE-T ports
VLANs	4094
Jumbo Frame	Up to 9KB
Power Supply	Internal power supply (depending on model)
Power over Ethernet (PoE)	No
Layer 3 Features	RIP
Quality of Service (QoS)	8 queues per port, DiffServ
Security Features	ACLs
Management	Web-based, CLI, SNMP
Operating Temperature	0°C to 40°C
Storage Temperature	-40°C to 70°C
SFP Ports	Combo 10/100/1000BASE-T/SFP ports and/or dedicated SFP/SFP+ ports (depending on model)