D-Link xStack DGS-3120 Series - Debug Stp State

xStack
®
DGS-3120 Series Layer 3 Managed Gigabit Ethernet Switch CLI Reference Guide
657
DGS-3120-24TC:admin# debug stp clear counter ports all
Command: debug stp clear counter ports all
Warning: only support local device.
Success.
DGS-3120-24TC:admin#
64-6 debug stp state
Description
This command is used to enable or disable the STP debug state.
Format
debug stp state [enable | disable]
Parameters
state - Specify the STP debug state.
enable - Enable the STP debug state.
disable - Disable the STP debug state.
Restrictions
Only Administrator-level users can issue this command.
Example
To configure the STP debug state to enable, and then disable the STP debug state:
DGS-3120-24TC:admin# debug stp state enable
Command: debug stp state enable
Success.
DGS-3120-24TC:admin# debug stp state disable
Command: debug stp state disable
Success.
DGS-3120-24TC:admin#
64-7 config stp trap
Description
This command is used to configure sending the STP traps.