D-Link xStack DGS-3120 Series - Chapter 90 RPC Portmapper Command List

xStack
®
DGS-3120 Series Layer 3 Managed Gigabit Ethernet Switch CLI Reference Guide
888
Chapter 90 RPC PortMapper Command
List
config filter rpc_portmapper [<portlist> | all] state [enable | disable]
show filter rpc_portmapper
90-1 config filter rpc_portmapper
Description
This command is used to configure the Switch to deny TCP/UDP packets with port number 135 on
the network.
Format
config filter rpc_portmapper [<portlist> | all] state [enable | disable]
Parameters
<portlist> - Specify a list of ports to be configured for the RPC portmapper filter state.
all - Specify all ports to be configured for the RPC portmapper filter state.
state - Specify the RPC portmapper filter state.
enable - Enable the RPC portmapper filter on specified ports.
disable - Disable the RPC portmapper filter on specified ports.
Restrictions
Only Administrator, Operator and Power-User level users can issue this command.
Example
To enable RPC portmapper filter on unit 1 port 1 to port 10:
DGS-3120-24TC:admin#config filter rpc_portmapper 1:1-1:10 state enable
Command: config filter rpc_portmapper 1:1-1:10 state enable
Success.
DGS-3120-24TC:admin#
90-2 show filter rpc_portmapper
Description
This command is used to display the RPC portmapper filter state on the Switch.
Format
show filter rpc_portmapper