D-Link xStack DGS-3120 Series - Config Wac User

xStack
®
DGS-3120 Series Layer 3 Managed Gigabit Ethernet Switch CLI Reference Guide
1099
Parameters
user - To specify the user name to be deleted
<username 15> - Enter the username used here. This name can be up to 15 characters long.
all_users - All user accounts in local DB will be deleted.
Restrictions
Only Administrator, Operator and Power-User level users can issue this command.
Example
To delete a WAC local user:
DGS-3120-24TC:admin# delete wac user 123
Command: delete wac user 123
Success.
DGS-3120-24TC:admin#
120-11 config wac user
Description
This command is used to update the local user DB. Only created user can be configured
Format
config wac user <username 15> [vlan <vlan_name 32> | vlanid <vlanid 1-4094> | clear_vlan]
Parameters
user - The user name to be configured.
<username 15> - Enter the username used here. This name can be up to 32 characters long.
vlan - Specify the VLAN name for authenticated host which uses this user account to pass
authentication.
<vlan_name 32> - Enter the name of the VLAN here. This name can be up to 32 characters
long.
vlanid - Target VLAN ID for authenticated host which uses this user account to pass
authentication.
<vlanid 1-4094> - Enter the VLAN ID used here. This value must be between 1 and 4094.
clear_vlan - Specify that the VLAN details for the specified user will be cleared.
Restrictions
Only Administrator, Operator and Power-User level users can issue this command.
Example
To configure WAC local user: