xStack
®
DGS-3120 Series Layer 3 Managed Gigabit Ethernet Switch CLI Reference Guide
852
Chapter 85
Reboot Schedule Command
List
config reboot schedule [in <min 1-43200> | at <end_time hh:mm> {<date ddmthyyyy>}]
{save_before_reboot}
85-1 config reboot schedule
Description
This command is used to configure reboot time and save parameters for the reboot schedule on
the Switch.
There are three parameters setting here. Users can configure the reboot time in two ways. The
first way is to configure the reboot after a specific interval time and the other way is to configure
the reboot at a specific date and time.
The third parameter determines whether to save the configuration or not before the reboot. The
reboot schedule won’t be saved to the configuration file. After a reboot or shutdown, the reboot
schedule will be deleted automatically. Even when the system is saved by using the save
command, the configuration of the reboot schedule also won't be saved.
Format
config reboot schedule [in <min 1-43200> | at <end_time hh:mm> {<date ddmthyyyy>}]
{save_before_reboot}
Parameters
in - Specify that the reboot will start after this time interval has passed.
<min 1-43200> - Enter the time value used here. This value must be between 1 and 43200
at - Specify that the reboot will take place on the specified time and date. If the date is not
specified, the reboot takes place at the specified time on the current day if the specified time is
later than the current time or on the next day if the specified time is earlier than the current
time.
<end_time hh:mm> - Enter the time here. Enter the two-digit hour (hh) value followed by a
colon (:) and then enter the two-digit minute (mm) value.
<date ddmthyyyy> - (Optional) Enter the date here. The date format is ddmthyyyy.
save_before_reboot - (Optional) Specify that the device will first save all configurations before
initiating the reboot.
Restrictions
Only Administrators, Operators and Power-Users can issue this command.
To Next Page
Loading...
Need help?
General
