D-Link xStack DGS-3120 Series - Show Snmp

xStack
®
DGS-3120 Series Layer 3 Managed Gigabit Ethernet Switch CLI Reference Guide
975
Parameters
host - The IP address of the recipient for which the traps are targeted.
<ipaddr> - Enter the IP address used for the configuration here.
v6host - The IPv6 address of the recipient for which the traps are targeted.
<ipv6addr> - Enter the IPv6 address used for the configuration here.
Restrictions
Only Administrator-level users can issue this command.
Example
To delete SNMP host “10.0.0.1”:
DGS-3120-24TC:admin# delete snmp host 10.0.0.1
Command: delete snmp host 10.0.0.1
Success.
DGS-3120-24TC:admin#
101-18 show snmp
Description
This command is used to display SNMP status.
Format
show snmp
Parameters
None.
Restrictions
None.
Example
To display SNMP: