D-Link xStack DGS-3120 Series User Manual

xStack
®
DGS-3120 Series Layer 3 Managed Gigabit Ethernet Switch CLI Reference Guide
1041
<start_time hh:mm> - Enter the starting time of Daylight Saving Time here. This value
must be in the hh:mm format.
<end_time hh:mm> - Enter the starting time of Daylight Saving Time here. This value
must be in the hh:mm format.
offset - (Optional) Indicates number of minutes to add or to subtract during summertime. The
ranges of offset are 30, 60, 90,120; default value is 60.
30 - Specify that the offset range will 30 minutes.
60 - Specify that the offset range will 60 minutes.
90 - Specify that the offset range will 90 minutes.
120 - Specify that the offset range will 120 minutes.
Restrictions
Only Administrator and Operator-level users can issue this command.
Example
To configure time:
DGS-3120-24TC:admin# config dst repeating s_week 2 s_day tue s_mth 4 s_time
15:00 e_week
2 e_day wed e_mth 10 e_time 15:30 offset 30
Command: config dst repeating s_week 2 s_day tue s_mth 4 s_time 15:00 e_week 2
e
_day wed e_mth 10 e_time 15:30 offset 30
Success.
DGS-3120-24TC:admin#
110-9 show time
Description
This command is used to display time states.
Format
show time
Parameters
None.
Restrictions
None.
Example
To show time:

D-Link xStack DGS-3120 Series Specifications

General

MAC Address Table	16K entries
Ports	10/100/1000BASE-T ports
VLANs	4094
Jumbo Frame	Up to 9KB
Power Supply	Internal power supply (depending on model)
Power over Ethernet (PoE)	No
Layer 3 Features	RIP
Quality of Service (QoS)	8 queues per port, DiffServ
Security Features	ACLs
Management	Web-based, CLI, SNMP
Operating Temperature	0°C to 40°C
Storage Temperature	-40°C to 70°C
SFP Ports	Combo 10/100/1000BASE-T/SFP ports and/or dedicated SFP/SFP+ ports (depending on model)