D-Link xStack DGS-3120 Series User Manual

xStack
®
DGS-3120 Series Layer 3 Managed Gigabit Ethernet Switch CLI Reference Guide
428
DGS-3120-24TC:admin#show igmp
Command: show igmp
IGMP Interface Configurations
Interface IP Address/Netmask Ver- Query Maximum Robust- Last State
sion Response ness Member
Time Value Query
Interval
------------ ------------------ ---- ------ -------- ------- -------- --------
System 10.90.90.90/8 2 125 10 2 1 Enabled
Total Entries: 1
DGS-3120-24TC:admin#
40-3 show igmp group
Description
This command is used to display the switch’s IGMP group table.
Format
show igmp group {group <multicast_ipaddr> | ipif <ipif_name 12>}
Parameters
group - (Optional) Specify the multicast group ID.
<multicast_ipaddr> - Enter the multicast group ID value here.
ipif - (Optional) Specify the IP interface name to be displayed
<ipif_name 12> - Enter the IP interface name, to be displayed, here. This name can be up to
12 characters long.
If no parameter is specified, the system will display all IGMP group tables.
Restrictions
None.
Example
To display the IGMP group table:

D-Link xStack DGS-3120 Series Specifications

General

MAC Address Table	16K entries
Ports	10/100/1000BASE-T ports
VLANs	4094
Jumbo Frame	Up to 9KB
Power Supply	Internal power supply (depending on model)
Power over Ethernet (PoE)	No
Layer 3 Features	RIP
Quality of Service (QoS)	8 queues per port, DiffServ
Security Features	ACLs
Management	Web-based, CLI, SNMP
Operating Temperature	0°C to 40°C
Storage Temperature	-40°C to 70°C
SFP Ports	Combo 10/100/1000BASE-T/SFP ports and/or dedicated SFP/SFP+ ports (depending on model)