D-Link xStack DGS-3120 Series User Manual

xStack
®
DGS-3120 Series Layer 3 Managed Gigabit Ethernet Switch CLI Reference Guide
543
Chapter 51 Layer 2 Protocol Tunneling
(L2PT) Command List
enable l2protocol_tunnel
disable l2protocol_tunnel
config l2protocol_tunnel ports [<portlist> | all] type [uni tunneled_protocol [{stp | gvrp |
protocol_mac [01-00-0C-CC-CC-CC | 01-00-0C-CC-CC-CD]}(1) | all] {threshold <value 0-
65535>} | nni | none]
show l2protocol_tunnel {[uni | nni]}
51-1 enable l2protocol_tunnel
Description
This command is used to enable the Layer 2 protocol tunneling function.
Format
enable l2protocol_tunnel
Parameters
None.
Restrictions
Only Administrator, Operator and Power-User level users can issue this command.
Example
To enable the Layer 2 protocol tunneling function:
DGS-3120-24TC:admin#enable l2protocol_tunnel
Command: enable l2protocol_tunnel
Success.
DGS-3120-24TC:admin#
51-2 disable l2protocol_tunnel
Description
This command is used to disable the L2PT function globally on the Switch.
Format
disable l2protocol_tunnel

D-Link xStack DGS-3120 Series Specifications

General

MAC Address Table	16K entries
Ports	10/100/1000BASE-T ports
VLANs	4094
Jumbo Frame	Up to 9KB
Power Supply	Internal power supply (depending on model)
Power over Ethernet (PoE)	No
Layer 3 Features	RIP
Quality of Service (QoS)	8 queues per port, DiffServ
Security Features	ACLs
Management	Web-based, CLI, SNMP
Operating Temperature	0°C to 40°C
Storage Temperature	-40°C to 70°C
SFP Ports	Combo 10/100/1000BASE-T/SFP ports and/or dedicated SFP/SFP+ ports (depending on model)