D-Link xStack DGS-3120 Series - Debug Config State

xStack
®
DGS-3120 Series Layer 3 Managed Gigabit Ethernet Switch CLI Reference Guide
249
DGS-3120-24TC:admin# debug config error_reboot disable
Command: debug config error_reboot disable
Success.
DGS-3120-24TC:admin#
22-6 debug config state
Description
This command is used to set the state of the debug.
Format
debug config state [enable | disable]
Parameters
enable - Enable the debug state.
disable - Disable the debug state.
Restrictions
Only Administrator-level users can issue this command.
Example
To set the debug state to disabled:
DGS-3120-24TC:admin# debug config state disable
Command: debug config state disable
Success.
DGS-3120-24TC:admin#
22-7 debug clear cpu port counter
Description
This command is used to clear cpu port counter.
Format
debug clear cpu port counter [<portlist> | all]
Parameters
<portlist> - Specify a range of ports.
all - Specify all ports.