D-Link xStack DGS-3120 Series - Chapter 101 Simple Network Management Protocol (SNMP) Command List

xStack
®
DGS-3120 Series Layer 3 Managed Gigabit Ethernet Switch CLI Reference Guide
961
Chapter 101 Simple Network
Management Protocol
(SNMP) Command List
create snmp community <community_string 32> view <view_name 32> [read_only | read_write]
create snmp community_masking view <view_name 32> [ read_only | read_write]
delete snmp community <community_string 32>
show snmp community {<community_string 32>}
create snmp user <user_name 32> <groupname 32> {encrypted [by_password auth [md5
<auth_password 8-16> | sha <auth_password 8-20>] priv [none | des <priv_password 8-16>] |
by_key auth [md5 <auth_key 32-32> | sha <auth_key 40-40>] priv [none | des <priv_key 32-
32>]]}
delete snmp user <username 32>
show snmp user
create snmp group <groupname 32> [v1 | v2c | v3 [noauth_nopriv | auth_nopriv | auth_priv]]
{read_view <view_name 32> | write_view <view_name 32> | notify_view <view_name 32>}
delete snmp group <groupname 32>
show snmp groups
create snmp view <view_name 32> <oid> view_type [included | excluded]
delete snmp view <view_name 32> [all | <oid>]
show snmp view {<view_name 32>}
enable snmp
disable snmp
create snmp [host <ipaddr> | v6host <ipv6addr>] [v1 | v2c | v3 [noauth_nopriv | auth_nopriv |
auth_priv]] <auth_string 32>
delete snmp [host <ipaddr> | v6host <ipv6addr>]
show snmp
show snmp host {<ipaddr>}
show snmp v6host {<ipv6addr>}
config snmp engineID <snmp_engineID 10-64>
show snmp engineID
config snmp system_name {<sw_name>}
config snmp system_location {<sw_location>}
config snmp system_contact {<sw_contact>}
enable snmp traps
disable snmp traps
enable snmp authenticate_traps
disable snmp authenticate_traps
enable snmp linkchange_traps
disable snmp linkchange_traps
config snmp linkchange_traps ports [all | <portlist>] [enable | disable]
config snmp coldstart_traps [enable | disable]
config snmp warmstart_traps [enable | disable]
show snmp traps {linkchange_traps {ports <portlist>}}
config rmon trap {rising_alarm [enable | disable] | falling_alarm [enable | disable]} (1)
show rmon
enable community_encryption
disable community_encryption
show community_encryption