D-Link xStack DGS-3120 Series - Show Snmp Traps; Config Rmon Trap

xStack
®
DGS-3120 Series Layer 3 Managed Gigabit Ethernet Switch CLI Reference Guide
986
Example
To configure the trap state for warmstart event:
DGS-3120-24TC:admin# config snmp warmstart_traps enable
Command: config snmp warmstart_traps enable
Success.
DGS-3120-24TC:admin#
101-35 show snmp traps
Description
This command is used to display the snmp trap sending status.
Format
show snmp traps {linkchange_traps {ports <portlist>}}
Parameters
linkchange_traps - (Optional) Specify that the SNMP trap sending status will be displayed.
ports - (Optional) Specify the ports for the display.
<portlist> - Enter the list of ports used for the display here.
Restrictions
None.
Example
DGS-3120-24TC:admin#show snmp traps
Command: show snmp traps
SNMP Traps : Enabled
Authenticate Traps : Enabled
Linkchange Traps : Enabled
Coldstart Traps : Enabled
Warmstart Traps : Enabled
DGS-3120-24TC:admin#
101-36 config rmon trap
Description
This command is used to configure the trap state for RMON events.