D-Link xStack DGS-3120 Series User Manual

xStack
®
DGS-3120 Series Layer 3 Managed Gigabit Ethernet Switch CLI Reference Guide
1058
Chapter 115 UDP Helper Command List
enable udp_helper
disable udp_helper
config udp_helper udp_port add [time | tacacs | dns | tftp | netbios-ns | netbios-ds |
<port_number 0-65535>]
config udp_helper udp_port delete [time | tacacs | dns | tftp | netbios-ns | netbios-ds
|<port_number 0-65535>]
config udp_helper add ipif <ipif_name 12> <ipaddr>
config udp_helper delete ipif <ipif_name 12> <ipaddr>
show udp_helper {[udp_port | ipif <ipif_name 12>]}
115-1 enable udp_helper
Description
This command is used to enable the UDP helper function on the Switch.
Format
enable udp_helper
Parameters
None.
Restrictions
Only Administrator, Operator and Power-User level users can issue this command.
Example
To enable the UDP helper function:
DGS-3120-24TC:admin#enable udp_helper
Command: enable udp_helper
Success.
DGS-3120-24TC:admin#
115-2 disable udp_helper
Description
This command is used to disable the UDP helper function on the Switch.
Format
disable udp_helper

D-Link xStack DGS-3120 Series Specifications

General

MAC Address Table	16K entries
Ports	10/100/1000BASE-T ports
VLANs	4094
Jumbo Frame	Up to 9KB
Power Supply	Internal power supply (depending on model)
Power over Ethernet (PoE)	No
Layer 3 Features	RIP
Quality of Service (QoS)	8 queues per port, DiffServ
Security Features	ACLs
Management	Web-based, CLI, SNMP
Operating Temperature	0°C to 40°C
Storage Temperature	-40°C to 70°C
SFP Ports	Combo 10/100/1000BASE-T/SFP ports and/or dedicated SFP/SFP+ ports (depending on model)