D-Link xStack DGS-3120 Series - Show Ipif

xStack
®
DGS-3120 Series Layer 3 Managed Gigabit Ethernet Switch CLI Reference Guide
167
DGS-3120-24TC:admin#disable ipif newone
Command: disable ipif newone
Success.
DGS-3120-24TC:admin#
12-18 show ipif
Description
This command is used to display an IP interface.
Format
show ipif {<ipif_name 12>}
Parameters
ipif_name - Specify the name of the IP interface.
<ipif_name 12> - (Optional) Enter the IP interface name used here. This name can be up to
12 characters long.
Restrictions
None.
Example
To display an IP interface:
DGS-3120-24TC:admin#show ipif
Command: show ipif
IP Interface : System
VLAN Name : default
Interface Admin State : Enabled
IPv4 Address : 10.90.90.90/8 (Manual) Primary
Proxy ARP : Disabled (Local : Disabled)
IP Directed Broadcast : Disabled
IPv4 State : Enabled
IPv6 SLAAC state : Disabled (Default Router: Disabled)
DHCPv6 Client State : Disabled (Rapid commit : Disabled)
IPv6 State : Enabled
DHCP Option12 State : Disabled
DHCP Option12 Host Name :
Total Entries: 1
DGS-3120-24TC:admin#